Click for Larger Image
|
HOUND HEATER DOG HOUSE HEATER
|
Keep your outdoor pet indoor warm! Hound Heater dog house furnace is a thermostatically controlled heater that installs in minutes and heats up to a 32 sq ft dog house. Simply set it and forget it. Has a new built-in 100,000 cycle, very accurate, thermostatCategory: Dog House HeaterThis dog house heater is powered by an extremely long life "Mica" heater - a special 150 watt heating element. This technology is one of the most reliable heaters in the world. Thermostat takes the guess work out. No more wondering what temperature your pet's dog house is. The Hound Heater Dog House Furnace can easily heat a well insulated dog house up to 32 cubic feet. The beauty of the new heater is, because it is thermostatically controlled, it can go in a small house as well. Once the pre-set temperature has been reached it will turn off and on only as needed to keep your pet warm and dry. Hound Heater Dog House Heater Features at a Glance:- Incredibly long-life heating element. Furnace's heating element and thermostat can also be replaced if needed.
- 100,000 cycle life thermostat. Simply set the thermostat and forget it!
- Thermo-sensing bulb allows for accurate control of the heat of your pet's house.
Estimated temperature settings: - Low: Approx 32°
- Medium to High: Approx 32° - 55°
- High: Approx 55° - 100°
- Saves Energy. Heater only runs when it is needed
- Internal and external heat shield for safety and efficiency. Can't burn your pets even if they lye directly against the lower portion of the unit.
- Overhead Heat Shield can be placed above the top of the Furnace and will disperse heat protecting the ceiling of your dog's house.
- Easy to install in square or igloo-shaped dog houses. New heating element is powerful enough to heat 32 Cubic Square Foot house, yet works perfectly in the smallest houses too.
- 10.5"H x 10"W x 5"D(protrusion from wall)
- AKHH1 has an 8 ft heavy-duty, spring-wrapped, chew-resistant cord. AKHH8 has an 8 ft non-wrapped cord.
Dog House Heater Mounting: Unit requires a measuring device, drill, 1-1/8" wood bit, screw driver and six sets of nuts, washers and bolts (not included)Mount the Hound Heater in any corner of the dog house away from the dog house entrance. Mount the Hound Heater Shield about 2" above the heater to deflect the rising heat and disperse it more efficiently in your pet's house. Plug it in. Set the thermostat to the desired temperature. Go away confident that it will heat when needed. (Can also be mounted in igloo-style dog houses the same as it would in a square house. It is important that you use nuts, bolts and washers instead of screws for mounting. It may sit slightly crooked but will work very well. The Hound Heater back stays cool so there is no problem or worry about melting the plastic)
|
Our
